1 800 antenna (268-3662) 37 cable assemblies/mounts all larsen nmohf (high frequency 27 mhz to 6 ghz) mounts convert from low frequency applications to high frequency applications and back by pulling or replacing the center pin and insulator. nmohf mounts require a 3/4 hole for mounting and include 17 of coax. nmohf mounts accommodate roof surfaces from 0.1 to .03. nmohfthk (thick) mounts accommodates roof surfaces up to 1/2?thick. nmo 3/4 hig h frequen cy moun ts model c oax c onnector nmokhfcx cx (rg-58a/u) no conn nmokhfcxfme cx (rg-58a/u) fme crimp nmokhfcxmpl cx (rg-58a/u) mpl nmokhfcxpl cx (rg-58a/u) pl-259 nmokhfds ds (rg-58a/u dual shield) no conn nmokhfud ud (rg-58u dual shield) no conn nmokhfudfme ud (rg-58u dual shield) fme nmokhfudmpl ud (rg-58u dual shield) mpl nmokhfudsma ud (rg-58u dual shield) sma nmokhfudtnc ud (rg-58u dual shield) tnc nmokhf200smai lmr200 sma installed nmo 3/4 high frequen cy thick moun ts model c oax c onnector nmokhfcxthk cx (rg-58a/u) no conn nmokhfdsthk ds (rg-58a/u dual shield) no conn nmohf thick mount low frequency confguration nmohf mount high frequency confguration nmohf mount low frequency confguration nmo 3/4 stan dard moun ts nmo 3/4 standard mounts require a 3/4 hole for mounting and include 17 of coax. model c oax c onnector nmoknoconn cx (rg-58a/u) no conn nmok cx (rg-58a/u) pl-259 nmokfme cx (rg-58a/u) fme nmokmpl cx (rg-58a/u) mpl crimp nmokds ds (rg-58a/u dual shield) no conn nmokdsfme ds (rg-58a/u dual shield) fme nmokud ud (rg-58u dual shield) no conn nmokudfme ud (rg-58u dual shield) fme nmokudpl ud (rg-58u dual shield) pl-259t nmokudtnc ud (rg-58u dual shield) tnc if your antenna has a tab or pin connector, use the nmohf mount in the low frequency confguration - leave the center pin and insulator in place as it arrives from the factory. if your antenna has a high frequency (hf) connector, use the nmohf mount in the high frequency confguration - remove the center pin and insulator. pin connector tab connector hf connector nmohf thick mount high frequency confguration
38 www.pulseelectronics.com/products/antennas cable assemblies/mounts all larsen nmohf (high frequency 27 mhz to 6 ghz) mounts convert from low frequency applications to high frequency applications and back by pulling or replacing the center pin and insulator. nmo high frequen cy m agnetic moun ts nmohf round magnetic mounts have the following specifcations: size: 3.5 diameter cable length: 12 pull strength: 80 lbs model c oax c onnector nmommrnoconn cx (rg-58a/u) no conn nm0mmr cx (rg-58a/u) 58fcp nmommrfme cx (rg-58a/u) fme crimp nmommrpl cx (rg-58a/u) pl-259 nmommrmpl cx (rg-58a/u) mpl crimp nmommrtnc cx (rg-58a/u) tnc crimp nmommrbnc cx (rg-58a/u) bnc crimp nmommrn cx (rg-58a/u) n crimp nmommrds ds (rg-58a/u dual shield) no conn nmommrdsfme ds (rg-58a/u dual shield) fme nmommrdsmpl ds (rg-58a/u dual shield) mpl crimp nmommrdsn ds (rg-58a/u dual shield) n crimp nmommrdssma ds (rg-58a/u dual shield) sma nmommrdssmar/p ds (rg-58a/u dual shield) smarp nmommrdspl ds (rg-58a/u dual shield) pl-259t nmommrdstnc ds (rg-58a/u dual shield) tnc nmommt200noconn lmr200 no conn nmommr200sma lmr200 sma nmommr200n lmr200 n nmo 3/8 thick moun ts nmo3/8 mounts have the following specifcations: mounting: 3/4 hole mounting surface: 0.15 to 0.22 thickness cable length: 17 model c oax c onnector NMOKCX38THK cx (rg-58a/u) no conn nmokud38thk ds (rg-58a/u dual shield) no conn
1 800 antenna (268-3662) 39 cable assemblies/mounts nmo square m agnetic moun ts nmo square magnetic mounts have the following specifcations: size: 3.5 x 3 cable length: 12 pull strength: 50 lbs model c oax c onnector nmommnoconn cx (rg-58a/u) no conn nmommmpl cx (rg-58a/u) mpl nmomm cx (rg-58a/u) 58fcp nmommbnc cx (rg-58a/u) bnc nmommpl cx (rg-58a/u) pl-259 nmommfme cx (rg-58a/u) fme nmommdsfme ds (rg-58a/u dual shield) fme nmo trunk lid moun ts nmo trunk lid mounts have the following specifcations: size: 2.5 x 2 cable length: 17 model c oax c onnector nmotlp cx (rg-58a/u) pl-259 nmotlpfme cx (rg-58a/u) fme all larsen nmohf (high frequency 27 mhz to 6 ghz) mounts convert from low frequency applications to high frequency applications and back by pull - ing or replacing the center pin and insulator. gps l te direct moun ts nmohfgps mounts have the following specifcations: frequency: 1575.4 - 1576.4 mhz gain: 5 dbic polarization: right-hand circular / vertical lna gain: 26 db 2 db cable: 16.4 rg-174 (gps) vswr: less than 2:1 16.4 rg-58 (nmohf) size: .5 x 2 x 4.5 voltage: 3 or 5 v dc color: black mounting: 5/8 hole model c onnectors nmohfgpsfmenoconn fme/no connector nmohfgpsfmesma fme/sma nmohfgpsnoconn no connectors nmohfgpssmasma sma/sma note: specifications listed refer to gps performance. additional antenna specifications are dependent on the antenna mounted on the nmo side.
40 www.pulseelectronics.com/products/antennas cable assemblies/mounts lm moun ts model c oax c onnector lmknoconn cx (rg-58a/u) no conn lmkfme cx (rg-58a/u) fme lmk cx (rg-58a/u) pl-259 lmkds ds (rg-58a/u dual shield) no conn lmkdsfme ds (rg-58a/u dual shield) fme lmkud ud (rg-58u dual shield) no conn lmkudfme ud (rg-58u dual shield) fme lmmm m agnetic moun ts lm magnetic mounts have the following specifcations: size: 3.5 x 3 cable length: 12 type: 5/16 x 24 thds pull strength: 50 lbs model c oax c onnector lmmmfme cx (rg-58a/u) fme crimp lmmmmpl cx (rg-58a/u) mpl crimp lmmm cx (rg-58a/u) 58fcp lmmmbnc cx (rg-58a/u) bnc crimp lmmmpl cx (rg-58a/u) pl-259 lmmmds ds (rg-58a/u dual shield) no conn lmmmsdfme ds (rg-58a/u dual shield) fme lm trunk lid moun ts lm trunk lid mounts have the following specifcations: size: 2.5 x 2 cable length: 17 type: 5/16 x 24 thds model c oax c onnector lmtlp cx (rg-58a/u) pl-259 lmtlpds ds (rg-58a/u dual shield) order separately po moun ts model c oax c onnector poknoconn cx (rg-58a/u) no conn po magnetic moun ts po magnetic mounts have the following specifcations: size: 3.5 x 3 cable length: 12 type: so-239 female pull strength: 50 lbs model c oax c onnector pomm cx (rg-58a/u) 58fcp
|