page 1 of 3 www.pduke.com 2014/4/30 fed30 series 30 watts dc - dc converter input specifications input voltage range 12vdc nominal input 24vdc nominal input 48vdc nominal input 9 ~ 18vdc 18 ~ 36vdc 36 ~ 75vdc input filter pi type input surge voltage 12vdc input 24vdc input 48vdc input 25vdc 100ms, max. 50vdc 100ms, max. 100vdc 100ms, max. input reflected ripple current 20map-p start up time nominal input and constant resistive load power up remote on/off 30ms 30ms start-up voltage 12vdc input 24vdc input 48vdc input 9vdc, max. 18vdc, max. 36vdc, max. shutdown voltage 12vdc input 24vdc input 48vdc input 8vdc 16vdc 32vdc remote on/off (note 5) (positive logic)(standard) (negative logic)(option) dc-dc on dc-dc off dc-dc on dc-dc off open or 3v < vr < 12v short or 0v < vr < 1.2v short or 0v < vr < 1.2v open or 3v < vr < 12v input current of remote control pin nominal input -0.5ma ~ +0.5ma remote off state input current nominal input 3ma environmental specifications -40oc to +50oc (without derating) operating ambient temperature +50oc to +85oc (with derating) maximum case temperature 105oc storage temperature range -55oc to +125oc over temperature protection 115oc thermal impedance (note 6) nature convection nature convection with heat-sink 12oc/watt 10oc/watt thermal shock mil-std-810f vibration mil-std-810f relative humidity 5% to 95% rh emc characteristics emi (note 7) en55022 class a, class b esd en61000-4-2 air contact 8kv 6kv perf. criteria a radiated immunity en61000-4-3 10 v/m perf. criteria a fast transient (note 8) en61000-4-4 2kv perf. criteria a surge (note 8) en61000-4-5 1kv perf. criteria a conducted immunity en61000-4-6 10 vr.m.s perf. criteria a output specifications output power 30 watts max. voltage accuracy 1% voltage adjustability single output 10% minimum load 0% line regulation ll to hl at full load 0.2% load regulation no load to full load single dual 0.5% 1% cross regulation (dual) asymmetrical load 25% / 100% fl 5% ripple and noise 20mhz bandwidth (measured with a 1uf/50v mlcc) 1.5-5.1vo 100mvp-p 12-15vo 150mvp-p temperature coefficient 0.02% / oc, max. transient response recovery time 25% load step change 250 s over voltage protection zener diode clamp 1.5v 2.5v 3.3v 5.0v & 5.1v & 5v 12v & 12v 15v & 15v output output output output output output 2.0v 3.3v 3.9v 6.2v 15v 18v over load protection % of fl at nominal input 150% short circuit protection continuous, automatics recovery general specifications efficiency see table isolation voltage input to output input (output) to case 1600vdc min. 1minute 1600vdc min. 1minute case grounding connect case to ?input with decoupl ing y cap isolation resistance 500vdc 10 9 ohms, min. isolation capacitance 1500pf, max. switching frequency 430khz 10% safety approvals iec60950-1, ul60950-1, & en60950-1 case material nickel-coated copper base material fr4 pcb potting material epoxy (ul94 v-0) dimensions 2.00 x 1.00 x 0.40 inch (50.8x 25.4 x 10.2 mm) weight 30.5g(1.07oz) mtbf (note 1) mil-hdbk-217f 1.453 x 10 6 hrs. t e c h n i c a l s p e c i f i c a t i o n all specifications are typical at nominal input, ful l load and 25oc otherwise noted features ? 30 watts maximum output power ? output current up to 8.5a ? standard 2.00 x 1.00 x 0.40 inch ? high efficiency up to 91% ? 2:1 wide input voltage range ? six-sided continuous shield ? fixed switching frequency ? ul60950-1, en60950-1, & iec60950-1 safety approvals ? ce marked ? compliant to rohs ii & reach options negative logic remote on/off description the fed30 series offer 30 watts of output power fro m a 2 x 1 x 0.4 inch package. fed30 series have 2:1 wide input voltage o f 9 ~ 18vdc, 18 ~ 36 and 36 ~ 75vdc. the fed30 series have features 1600vdc of is olation, short circuit protection, over-current protection, over-voltage p rotection, over-temperature protection and six sided shielding. applications wireless network telecom/datacom industry control system measurement semiconductor equipment
page 2 of 3 www.pduke.com 2014/4/30 fed30 series 30 watts dc - dc converter output current no load (2) model number input range output voltage min. load max. load output (3) ripple & noise input current eff ( 3 ) (%) capacitor ( 4 ) load max fed30-12s1p5 9 ~ 18 vdc 1.5 vdc 0ma 8500ma 100mvp-p 70ma 79 20000 f fed30-12s2p5 9 ~ 18 vdc 2.5 vdc 0ma 8000ma 100mvp-p 100ma 84 20000 f fed30-12s3p3 9 ~ 18 vdc 3.3 vdc 0ma 8000ma 100mvp-p 90ma 85 20000 f fed30-12s05 9 ~ 18 vdc 5.0 vdc 0ma 6000ma 100mvp-p 130ma 87 14400 f fed30-12s5p1 9 ~ 18 vdc 5.1 vdc 0ma 6000ma 100mvp-p 130ma 87 14400 f fed30-12s12 9 ~ 18 vdc 12 vdc 0ma 2500ma 150mvp-p 90ma 89 3000 f fed30-12s15 9 ~ 18 vdc 15 vdc 0ma 2000ma 150mvp-p 80ma 89 2000 f fed30-12d05 9 ~ 18 vdc 5vdc 0ma 3000ma 100mvp-p 90ma 87 3000 f fed30-12d12 9 ~ 18 vdc 12vdc 0ma 1250ma 150mvp-p 50ma 87 2000 f fed30-12d15 9 ~ 18 vdc 15vdc 0ma 1000ma 150mvp-p 40ma 87 1300 f fed30-24s1p5 18 ~ 36 vdc 1.5 vdc 0ma 8500ma 100mvp-p 50ma 80 20000 f fed30-24s2p5 18 ~ 36 vdc 2.5 vdc 0ma 8000ma 100mvp-p 50ma 85 20000 f fed30-24s3p3 18 ~ 36 vdc 3.3 vdc 0ma 8000ma 100mvp-p 50ma 87 20000 f fed30-24s05 18 ~36 vdc 5.0 vdc 0ma 6000ma 100mvp-p 75ma 90 14400 f fed30-24s5p1 18 ~ 36 vdc 5.1 vdc 0ma 6000ma 100mvp-p 75ma 90 14400 f fed30-24s12 18 ~ 36 vdc 12 vdc 0ma 2500ma 150mvp-p 40ma 91 3000 f fed30-24s15 18 ~ 36 vdc 15 vdc 0ma 2000ma 150mvp-p 30ma 91 2000 f fed30-24d05 18 ~ 36 vdc 5vdc 0ma 3000ma 100mvp-p 70ma 90 3000 f fed30-24d12 18 ~ 36 vdc 12vdc 0ma 1250ma 150mvp-p 30ma 89 2000 f fed30-24d15 18 ~ 36 vdc 15vdc 0ma 1000ma 150mvp-p 30ma 90 1300 f fed30-48s1p5 36 ~ 75 vdc 1.5 vdc 0ma 8500ma 100mvp-p 45ma 80 20000 f fed30-48s2p5 36 ~ 75 vdc 2.5 vdc 0ma 8000ma 100mvp-p 45ma 85 20000 f fed30-48s3p3 36 ~ 75 vdc 3.3 vdc 0ma 8000ma 100mvp-p 30ma 87 20000 f fed30-48s05 36 ~ 75 vdc 5.0 vdc 0ma 6000ma 100mvp-p 45ma 90 14400 f FED30-48S5P1 36 ~ 75 vdc 5.1 vdc 0ma 6000ma 100mvp-p 45ma 89 14400 f fed30-48s12 36 ~ 75 vdc 12 vdc 0ma 2500ma 150mvp-p 40ma 91 3000 f fed30-48s15 36 ~ 75 vdc 15 vdc 0ma 2000ma 150mvp-p 40ma 91 2000 f fed30-48d05 36 ~ 75 vdc 5vdc 0ma 3000ma 100mvp-p 35ma 90 3000 f fed30-48d12 36 ~ 75 vdc 12vdc 0ma 1250ma 150mvp-p 30ma 88 2000 f fed30-48d15 36 ~ 75 vdc 15vdc 0ma 1000ma 150mvp-p 20ma 89 1300 f note 1. mil-hdbk-217f @ta=25 oc, full load. 2. typical value at nominal input voltage and no load . 3. typical value at nominal input voltage and full lo ad. 4. test by minimum input and constant resistive load. 5. the ctrl pin voltage is referenced to -input. 6. heat-sink is optional and p/n: 7g-0020a-f. 7. the fed30 series standard module meets en55022 cla ss a and class b with external components. for more detail information, please contact with p- duke. 8. an external filter capacitor is required if the mo dule has to meet en61000-4-4,en61000-4-5. the filter capacitor power mate suggest: 12 vdc inp ut & 24 vdc input : nippon chemi-con ky series, 330 f/50v. 48 vdc input : nippon chemi-con ky series, 220 f/100v. caution: this power module is not internally fused. an inpu t line fuse must always be used. efficiency (%) fed30-48s05 efficiency vs output load 85% 87% 89% 91% 93% 95% 36 40 44 48 52 56 60 64 68 72 76 input voltage (v) fed30-48s05 efficiency vs input voltage fed30-48s05 efficiency vs output load 55 60 65 70 75 80 85 90 95 10 20 30 40 50 60 70 80 90 100 output load (% of full load) efficiency (%) fed30-48s05 efficiency vs output load output power (%) 0 20 40 60 80 100 120 -40 -20 0 20 40 60 80 100 120 ambient temperature( ) 71 fed30-48s05 derating curve with heat-sink 0 20 40 60 80 100 120 -40 -20 0 20 40 60 80 100 120 ambient temperature( ) output power (%) 65 fed30-48s05 derating curve
page 3 of 3 www.pduke.com 2014/4/30 fed30 series 30 watts dc - dc converter mechanical drawing pin connection pin single dual 1 + input + input 2 - input - input 3 ctrl ctrl 4 + output + output 5 - output common 6 trim - output 1. all dimensions in inch (mm) tolerance: x.xx0.02 (x.x0.5) x.xxx0.01 (x.xx0.25) 2. pin pitch tolerance 0.01(0.25) 3. pin dimension tolerance 0.004 (0.1) output can be externally trimmed by using the method shown below. external output trimming 6 5 trim up 6 4 trim down r u r d
|
