ilpa100ju series 100w water - proof constant current led driver C wide input voltage 90 to 305vac, 47 to 63hz C constant output current available from 350ma to 4200ma C over voltage, short circuit, lighting, and over temperature protection C high efficiency (up to 92%) C active power factor correction (pfc) (99% typical) C ip67 waterproof rating, metal housing C comply with ul8750 & en61347 safety regulation 2 year warranty approvals: single output part number output current range (min. / typ. / max.) output voltage (min. / max.) efficiency (220vac, full load) over voltage protection (min. / typ. / max.) max. output power ilpa100ju - s420st 3990 / 4200 / 4410 ma 14 / 24 vdc 90.5% 28 / 31 / 34 vdc 100w ilpa100ju - s357st 3391 / 3570 / 3748 ma 17 / 28 vdc 90.5% 33 / 36 / 40 vdc 100w ilpa100ju - s315st 2992 / 3150 / 3307 ma 19 / 32 vdc 90.5% 38 / 42 / 45 vdc 100w ilpa100ju - s280st 2660 / 2800 / 2940 ma 22 / 36 vdc 90.5% 43 / 47 / 51 vdc 100w ilpa100ju - s245st 2327 / 2450 / 2572 ma 25 / 41 vdc 91% 49 / 53 / 58 vdc 100w ilpa100ju - s210st 1995 / 2100 / 2205 ma 29 / 48 vdc 91% 57 / 63 / 67 vdc 100w ilpa100ju - s175st 1662 / 1750 / 1837 ma 34 / 57 vdc 91% 68 / 74 / 80 vdc 100w ilpa100ju - s140st 1330 / 1400 / 1470 ma 43 / 71 vdc 91% 86 / 94 / 101 vdc 100w ilpa100ju - s105st 997 / 1050 / 1102 ma 57 / 95 vdc 91% 114 / 124 / 133 vdc 100w ilpa100ju - s070st 665 / 700 / 735 ma 86 / 143 vdc 91% 171 / 186 / 200 vdc 100w ilpa100ju - s045st 427 / 450 / 473 ma 132 / 222 vdc 92% 266 / 289 / 311 vdc 100w ilpa100ju - s035st 332 / 350 / 368 ma 172 / 286 vdc 92% 343 / 372 / 401 vdc 100w electrical characteristics parameter test conditions min. typ. max. unit input voltage operating voltage 90 305 vac input frequency 47 63 hz output power range vin=90 to 305vac 0 100 w input current (low line) io=full load, vin=115vac 1.30 a input current (high line) io=full load, vin=230vac 0.60 a high line inrush current io=full load, 25c, cool start, vin=230vac 65 a power factor correction vin=110vac 96 99 % efficiency io=full load, vin=220vac 88 92 % line regulation io=full load 1 % load regulation vin=230vac 5 % over voltage protection latch mode. the power unit shall return to normal operation only after the power is turn - on again. (please refer to output table.) over temperature protection 110 c short circuit protection no damage shall occur when any output operating in a short circuit condition. the power supply shall be self - recovery when the fault condition is removed. output overshoot / undershoot when power on or off 10 % start up time io=full load, vin=100vac 0.6 1 s ripple & noise (peak to peak) measured by 20 mhz bandwidth oscilloscope and the output paralleled a 0.1 uf ceramic capacitor and a 10 uf electrolytic capacitor. 5 % vo
conditions parameter test conditions min. typ. max. unit operating temperature humidity: 10% rh to 100% rh - 35 70 c storage temperature humidity: 5% rh to 100% rh - 40 85 c mtbf: operation temperature at 25c, calculated per mil - hdbk - 217f 0.478m hours life time at 25c ambient temperature 0.104m hours approvals and compliance parameter standards emi en55015 ems en61000 - 3 - 2, en61000 - 3 - 3, en61000 - 4 - 2, en61000 - 4 - 3, , en61000 - 4 - 4, , en61000 - 4 - 5, en6 1000 - 4 - 6, en61000 - 4 - 8, en61000 - 4 - 11, en61547 safety ul/c - ul, ce ul8750 compliant to ul1310 clast 2, ul1012, ul935, csa - c22.2 no. 0, csa - c22.2 no. 107.1, csa - c22.2 no.250.0, en61347 - 1,en61347 - 2 - 13 waterproof ip67 rating mechanical parameter specification dimension, 194x67.5x37mm (7.64x2.66x1.46 inches) net weight 1000g approx.
|