description document no. 4807102-001.b00 04/22/15 page 1 specifications *power will vary depending on the sdram used. hx324c11t2k2/8 8gb (4gb 512m x 64-bit x 2 pcs.) ddr3-2400 cl11 240-pin dimm kit continued >> kingston.com/hyperx features ? jedec standard 1.5v (1.425v ~ 1.575v) power supply ? vddq = 1.5v (1.425v ~ 1.575v) ? 800mhz fck for 1600mb/sec/pin ? 8 independent internal banks ? programmable cas latency: 11, 10, 9, 8, 7, 6 ? programmable additive latency: 0, cl - 2, or cl - 1 clock ? 8-bit pre-fetch ? burst length: 8 (interleave without any limit, sequential with starting address ?000? only), 4 with tccd = 4 which does not allow seamless read or write (either on the fly using a12 or mrs) ? bi-directional differential data strobe ? internal (self) calibration: internal self calibration through zq pin (rzq: 240 ohm 1%) ? on die termination using odt pin ? average refresh period 7.8us at lower than tcase 85c, 3.9us at 85c < tcase < 95co ? asynchronous reset ? height 2.118? (53.80mm), w/heatsink, single sided component cl(idd) row cycle time (trcmin) refresh to active/refresh command time (trfcmin) row active time (trasmin) maximum operating power ul rating operating temperature storage temperature 11 cycles 48.125ns(min.) 260ns(min.) 35ns(min.) tbd w* 94 v - 0 0 o c to +85 o c -55 o c to +100 o c xmp timing parameters ? jedec: ddr3-1600 cl11-11-11 @1.5v ? xmp profile #1: ddr3-2400 cl11-13-14 @1.65v ? xmp profile #2: ddr3-2133 cl11-13-13 @1.6v hyperx hx324c11t2k2/8 is a kit of two 512m x 64-bit (4gb) ddr3-2400 cl11 sdram (synchronous dram), 1rx8 memory modules, based on eight 512m x 8-bit fbga components per module. each module kit supports intel? xmp (extreme memory profiles). total kit capacity is 8gb. each module kit has been tested to run at ddr3-2400 at a low latency timing of 11-13-14 at 1.65v. the spds are programmed to jedec standard latency ddr3-1600 timing of 11-11-11 at 1.5v. each 240-pin dimm uses gold contact fingers. the jedec standard electrical and mechanical specifications are as follows:
document no. 4807102-001 .b00 page 2 continued hyperx for more information, go to www.kingston.com/hyperx kingston.com/hyperx all kingston products are tested to meet our published specifications. some motherboards or system configurations may not opera te at the published hyperx memory speeds and timing settings. kingston does not recommend that any user attempt to run their computers fa ster than the published speed. overclocking or modifying your system timing may result in damage to computer components. module dimensions module with heat spreader 133.35 mm 53.8 mm 8.12 mm
|
