lb05s thru lb10s miniature glass passivated single-phase surface mount bridge rectifier reverse voltage: 50 to 1000 volts forward current: 0.5 ampere features surge overload rating: 30 amperes peak lbxs ideal for printed circuit board plastic material has underwriters laboratory flammability classification 94v-0 low leakage reliable low cost construction utilizing molded mechanical data case: molded plastic, lbxs epoxy: ul 94v-o rate flame retardant terminals: leads solderable per mil-std-202, method 208 guaranteed mounting position: any weight: 0.00528ounce, 0.134gram maximum ratings and electrical characteristics ratings at 25 ambient temperature unless otherwise specified. single phase, half wave, 60h z , resistive or inductive load. lb05s lb1s lb2s LB4S lb6s lb8s lb10s units maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 volts maximum rms voltage v rms 35 70 140 280 420 560 700 volts maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 volts maximum average forward rectified current (see fig. 1) on glass-epoxy p.c.b (note 2) on aluminum substrate (note 3) peak forward surge current, 8.3ms single half-sine-wave superimposed on rated load (jedec method) maximum forward voltage at 0.4a dc and 25 maximum reverse current at t a =25 at rated dc blocking voltage t a =125 typical junction capacitance (note 1) c j pf typical thermal resistance (note 3) r ja /w typical thermal resistance (note 2) r jl /w operating and storage temperature range t j tstg notes: 1- measured at 1 mh z and applied reverse voltage of 4.0 vdc. 2- on glass epoxy p.c.b. mounted on 0.05 x 0.05" (1.3 x 1.3mm) pads 3- on aluminum substrate p.c.b. with an area of 0.8" x 0.8" (20 x 20mm) mounted on 0.05 x 0.05" (1.3 x 1.3mm) solder pad -55 to +150 5.0 500 13 16 60 dimensions in inches and (millimeters) i fsm v f 30 0.8 0.5 i (av) amp i r amp volts uamp 1.0 mdd electronics
miniature glass passivated single-phase surface mount bridge rectifier characteristic curves (ta=25 unless otherwise noted) mdd electronics
|
