Part Number Hot Search : 
B15E0 72102E3 BPX300 74HCT3 TN0606 C2637 TEA19161 100CA
Product Description
Full Text Search
 

To Download GW12LJPD Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
  series gw ultra-thin fully illuminated paddles www.nkk.com b36 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable b rockers touch tilt toggles general specifcations electrical capacity (resistive load) logic level: 0.4va maximum @ 28v ac/dc maximum (applicable range 0.1ma ~ 0.1a @ 20mv ~ 28v) note: find additional explanation of operating range in supplement section. other ratings contact resistance: 80 milliohms maximum insulation resistance: 500 megohms minimum @ 500v dc dielectric strength: 500v ac minimum for 1 minute minimum mechanical life: 50,000 operations minimum electrical life: 50,000 operations minimum nominal operating force: 1.0n angle of throw: 28 materials & finishes actuator: polycarbonate resin (ul94v-0) case: glass fber reinforced polyamide (ul94v-0) sealing ring: nitrile butadiene rubber base: glass fber reinforced polyamide movable contact: phosphor bronze with gold plating stationary contact: phosphor bronze with gold plating terminals: phosphor bronze with gold plating environmental data operating temperature range: C25c through +55c (C13f through +131f) humidity: 90 ~ 95% humidity for 240 hours @ 40c (104f) vibration: 10 ~ 55hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for 2 hours shock: 50g (490m/s 2 ) acceleration (tested in 3 right angled directions, with 5 shocks in each direction) pcb processing soldering: wave soldering recommended. see profle a in supplement section. manual soldering: see profle a in supplement section. cleaning: these devices are not process sealed. hand clean locally using alcohol based solution. standards & certifications flammability standard: ul94v-0 actuator & case the gw series illuminated paddles have not been tested for ul recognition or csa certifcation. these switches are designed for use in a low-voltage, low-current, logic-level circuit. when used as intended in a logic-level circuit, the results do not produce hazardous energy.
series gw ultra-thin fully illuminated paddles www.nkk.com b37 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable toggles b rockers touch tilt distinctive characteristics actual size worlds smallest fully illuminated paddles (patent pending) for highly visible status indication; leds available in red, green, or amber for single color and red/green for bicolor. specially designed switching mechanism provides crisp actuation feedback to positively indicate circuit transfer (patent pending). insert molded terminals prevent entry of fux and other contaminants. award-winning stc contact mechanism with benefts unavailable in conventional mechanisms: smoother, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (additional stc details in terms & acronyms; see supplement section.) .100 x .100 (2.54mm x 2.54mm) terminal spacing conforms to standard pc board grid spacing for straight and angle mounting.
series gw ultra-thin fully illuminated paddles www.nkk.com b38 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable b rockers touch tilt toggles pole 1 spdt typical switch ordering example 1 gw circuit 2 on none on led colors single color c red d amber f green bicolor cf red/green 2 j d pc terminals p straight h right angle v vertical p actuator l paddle actuator color j clear l description for typical paddle ordering example GW12LJPD straight pc terminals spdt on-none-on circuit clear paddle amber led paddle position connected terminals throw & schematics pole model up center down up center down sp gw12 on none on 2-3 open 2-1 spdt pole & circuit (5) (6) (5) (4) red (6) green note: terminal numbers are not actually on the switch. led circuit is isolated and requires an external power source. single color bicolor led colors & specifications leds are an integral part of the the switch and not available separately. the electrical specifcations shown are determined at a basic temperature of 25c. if the source voltage exceeds the rated voltage, a ballast resistor is required. the resistor value can be calculated by using the formula in the supplement section. single color bicolor red amber green red/green forward peak current i fm 25ma 25ma 25ma 25ma/25ma typical forward current i f 20ma 20ma 20ma 20ma/20ma forward voltage v f 2.0v 2.1v 2.1v 2.0v/2.1v reverse peak voltage v rm 4v 4v 4v 4v/4v current reduction rate above 25c ?i f 0.33ma/c 0.33ma/c 0.33ma/c 0.33ma/c ambient temperature range C25c ~ +55c d cf f c colors 2 (com) 1 3
series gw ultra-thin fully illuminated paddles www.nkk.com b39 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable toggles b rockers touch tilt typical switch dimensions straight pc 5 & 6 are led terminals; 4 is a support pin on single color models & an led terminal on bicolor models. gw12ljpc 5 & 6 are led terminals; 4 is a support pin on single color models & an led terminal on bicolor models. gw12ljhd 5 & 6 are led terminals; 4 is a support pin on single color models & an led terminal on bicolor models. gw12ljvcf vertical pc right angle pc (0.25) ty p .010 (0.25) ty p .010 (3.0) .118 (4.5) .177 (7.0) .276 (2.6) .102 (3.8) .150 (7.0) .276 (2.6) .102 28 p/n this side (0.4) dia ty p .016 (2.54) ty p .100 (2.54) .100 4 5 6 1 2 3 (5.15) .203 (7.0) .276 (5.08) .200 (0.25) .010 (2.9) .114 (7.5) .295 (0.5) ty p .020 (3.0) .118 (2.6) .102 p/n this side (4.5) .177 (2.75) .108 (0.25) .010 (5.08) .200 (10.22) .402 (0.5) .020 (2.54) .100 65 4 (0.4) dia ty p .016 (2.54) ty p .100 32 1 (3.8) .150 28 (4.5) .177 (5.0) .197 (0.5) ty p .020 (0.25) ty p .010 (4.15) .163 (7.65) .301 (2.54) .100 1 2 3 4 5 6 (0.4) dia .016 (2.54) .100 (0.6) dia ty p .024 (2.54) ty p .100 (2.54) .100 1 2 3 4 5 6 (0.6) dia ty p .024 (2.54) ty p .100 (2.54) .100 12 3 45 6 (5.08) .200 (0.6) dia ty p .024 (5.08) .200 (2.54) ty p .100 (2.54) .100 1 2 3 4 5 6 (12.76) .502 p/n this side (2.54) ty p .100 (3.8) .150 28 (0.25) .010 (2.75) .108 (0.5) ty p .020 (5.08) .200


▲Up To Search▲   

 
Price & Availability of GW12LJPD

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X