v360epc rev a0 enhanced pci bridge controller for 32-bit de-multiplexed address/data applications glueless interface to intel s i960 cx/hx and amd?9030/40 processors fully compliant with pci 2.1 specification configurable for primary master, bus master, or target operation type 0 and type 1 configuration cycles up to 1kbyte burst access on pci or local 64 bytes of read fifo per aperture 640 bytes of programmable fifo with dynamic bandwidth allocation on-the-fly byte order (endian) conversion up to 50mhz local bus 3.3 volt support i 2 o atu and messaging unit including hardware controlled circular queues two-channel dma plus multiprocessor dma chaining and demand mode dma hot swap capability enhanced support for 8/16-bit local bus devices with programmable region sizes 16 8-bit bi-directional mailbox registers with doorbell interrupts optional power-on serial eeprom initialization support for real-mode dos ?oles low-cost 160-pin pqfp package industrial temperature grade design -40? to +85? block diagram
two unique features of the v360epc make it the highest perfor- mance pci bridge on the market. one is the size of the fifo struc- ture; 640 bytes of fifo storage gives you plenty of buffering to handle continuous transfers of large data streams without tying up the local or pci buses. the dynamic bandwidth alloca- tion feature of the fifos allows you to adjust the ?raining and ?illing?of the read and write fifos to most efficiently meet the requirements of the data streams. you can balance your bus uti- lization to maximize overall system performance. the priority of reads, writes, and fifo flushes can be independently programmed to maintain strict data coherency. the v360epc provides the most flexible, highest performance, and economical way to add pci connectivity to applications like imaging and networking. whether you?e creating a system with the i960 or powerpc cpu as the pci master or designing an intel- ligent add-in card, or even a processor-less application, the v360epc from v3 semiconductor is the ideal choice. about v3 semiconductor v3 semiconductor has been providing embedded systems design ers with innovative products since 1987. v3 products are supported throughout north america, europe, the middle east and the far east by a network of distributors and manufacturers representatives. for more information on the v360epc, or our other i960? and powerpc processors support components, please contact: cost effective solutions that simplify embedded system design! v3 semiconductor 2348g walsh ave. santa clara, ca 95051 phone: (408)988-1050 fax: (408)988-2601 toll free: (800)488-8410 (canada and us) www.vcubed.com / or www.v3semiconductor.com typical applica tions ?997 v3 semiconductor corp. v3 semiconductor retains the right to make changes to either the documentation, specification or c omponent without notice. i960 is a registered trademark of intel corporation. powerpc is a trademark of ibm corporation. intelligent target-only application target-only application v360epc 1 2 0 ready
|
