611 industrial way west, eatontown, nj 07724 tel: 732-460- 0212 fax: 732-460-0214 sales@advanced-control.com www.a dvanced-control.com features: ? exceptional temperature stability ? low video resistance (112 ? typical) ? flat output vs. frequency over broadband performance ? very fast pulse response ? no bias required ? flexible design options applications: ? transmitter monitoring ? missile guidance systems ? input to low-noise amplifiers ? broadband or narrowband ecm receivers ? power and signal monitors ? doppler radar and beacon receivers ? matched units available for mult i-channel receivers, amplitude comparator systems and discriminators minimum (2) flatness nominal (5) frequency sensitivity vs typical (3) video standard optional range part (1) k frequency tss typical (4) capacitance case case (ghz) number (mv/mw) (+/-db) (dbm) vswr (pf) styles styles 0.1 - 0.5 actp1523n 800 0.3 -51 2.5:1 270 c3 c8,c15,c62 0.1 - 1 actp1572n 900 0.4 -51 2.5:1 270 c3 c8,c15,c62 0.5 - 1 actp1524n 800 0.2 -51 2.5:1 39 c3 c8,c15 0.1 - 2 actp1629n 900 0.35 -51 2.3:1 75 c3 c8,c15,c62 0.5 - 2 actp1501n 800 0.35 -51 2.3:1 39 c3 c15 1 - 2 actp1525n 800 0.25 -51 2.5:1 20 c3 c15 0.1 - 4 actp1573n 800 0.3 -51 2.3:1 75 c3 c8,c15,c62 2 - 4 actp1502n 800 0.2 -51 2.3:1 20 c3 c15 2 - 6 actp1514n 800 0.5 -51 2.3:1 20 c32 c3,c5,c15 1 - 12 actp1663n 700 0.85 -50 2.5:1 20 c3 c8,c15,c62 2 - 8 actp1555n 750 0.5 -51 2.5:1 20 c3 c8,c15 4 - 8 actp1503n 750 0.4 -51 2.5:1 9 c3 c32 4 - 8 actp1648n 650 0.4 -50 2.0:1 12 c8 c15 6 - 12 actp1583n 750 0.4 -50 2.5:1 12 c3 c8,c15 8 - 12 actp1504n 700 0.4 -50 2.4:1 9 c3 - 2 - 18 actp1528n 650 1.0 -50 2.8:1 12 c3 c32 0.5 - 18 actp1584n 600 1.3 -50 3.0:1 20 c32 c3,c15 1 - 18 actp1625n 650 1.1 -50 2.7:1 20 c32 c3,c15 6 - 18 actp1563n 600 0.9 -50 2.8:1 12 c32 c3,c15 7 - 18 actp1662n 650 1.0 -50 2.7:1 12 c32 c3 8 - 18 actp1506n 650 0.7 -50 2.3:1 12 c3 - 12 - 18 actp1505n 700 0.4 -51 2.1:1 9 c3 - notes: 1) standard output polarity is negative. if positive output is required, substitute ?p? for ?n? in part number. 2) diode values can be changed to alter the le vel of sensitivity. as sensitivity is increased, vswr will degrade. vswr will i mprove as sensitivity is lowered. flatness and tss will also be influenc ed by these changes. if your applic ations require something spe cial, please contact the factory. 3) tangential signal sensitivity (tss) is a measure of low level sensitivity with respect to noi se. it is measured using a vid eo amplifier with a 2mhz bandwidth and a 3db noise figure. 4) vswr measured at or below -20dbm input power level. 5) video capacitance is used for rf bypass. this value can be changed if required for video response time or other considerati ons. contact the factory if value other than those shown are needed. superior performance and high reliabilit y are designed into these detectors. they offer extremely stable output voltage over wide temperature excursions, typically +/-0.15db from -65c to +100c at 1ghz and approx. +/-0.3db at 18ghz. no bias is required for operation. designs are available, in selected frequency bands, from 100mhz (or lower) to 18ghz. typical output impedance is in the range of 95 ? to 125 ? . this allows for fast pulsed video response and use in wide bandwidth requirements. video bandwidths may be modified by selection of the rf bypass capacitor and load value. square law typically ranges from tss up to -17dbm. the upper limit can be raised as high as - 13dbm with selected load values. the output polarity is usually negative but can be made positive if requested. coaxial tunnel diode detectors
611 industrial way west, eatontown, nj 07724 tel: 732-460- 0212 fax: 732-460-0214 sales@advanced-control.com www.a dvanced-control.com environmental specifications: screening : mil-e-5400, mil-std-202, mil-e-16400 standard screening : operating temp: -65c to +100c internal visual per mil-std-883, method 2017 storage temp: -65c to +100c temperature cycle: -65c to +100c, 10 cycles humidity: mil-std-202f, m103, cond b op tional high-rel screening (ref mil-prf-38534) : shock: mil-std-202f, m213, cond b internal visual per mil-std-883, method 2017 altitude: mil-std-202f, m105, cond b stabilization bake per mil-std-883, method 1008 vibration : mil-std-202f, m204, cond b temperature cycle per mil-std-883, method 1010 thermal shock: mil-std-202f, m107, cond a c onstant acceleration per mil-std-883, method 2001 temperature cycle: mil-std-202f, m105c, cond d burn-in per mil-std-883, method 1015 maximum input power: +14dbm leak test per mil-std-883, method 1014 (this allows for 3db margin from possible burnout at +17dbm) external visual per mil-std-883, method 2009 case style c3 case style c5 case style c8 case style c15 case style c32 case style 62 part number ordering information: example: actp1555nc312 actp1555: coaxial tunnel diode detector, 2 ? 8ghz n: negative output polarity c3: package type 12: 12pf custom video capacitance (omit for standard value) tp-0106 2.800.020 bnc female (output) ?0.625 type-n male (input) ?0.312 1.320.020 sma male (input) sma female (output) bnc female (output) sma male (input) 2.00 0.43 0.42 ?0.500 ?0.312 sma female (output) sma male (input) 1.160.020 sma female (output) ?0.312 sma female (input) 1.220.050 sma female (output) sma male (input) ?0.312 1.550.020
|
