? glass passivated device ? ideal for surface mouted applications ? low leakage current ? metallurgically bonded construction ? case:jedec do-213ab,molded plastic over passivated chip ? polarity: color band denotes cathode end ? weight: 0.0046 ounces, 0.116 gram ? mounting position: any maximum ratings and electrical characteristics ratings at 25 ?? ambient temperature unless otherwise specified. single phase,half wave,60hz,resistive or inductive load.for capactive load,derate current by 20%. 4001 4003 4004 4005 4006 4007 maximum recurrent peak reverse voltage v rrm 50 200 400 600 800 1000 v maximum rms voltage v rms 35 140 280 420 560 700 v maximum dc blocking voltage v dc 50 200 400 600 800 1000 v maximum average forword rectified current t a =50?? peak forward surge current 8.3ms single half-sine-wave superimposed on rated load (jedec method) maximum forward voltage at 1.0a v f v maximum dc reverse current @t j =25?? at rated dc blockjing voltage @t j =100?? maximum reverse recovery time (note1) t rr ns typical thermal resistance (note 2) r j t k/w typical thermal resistance (note 3) r j a k/w operating temperature range t j ?? storage temperature range t stg ?? 2. thermal resistance junction to terminal, 6.0 mm 2 coppeer pads to each terminal. 3. thermal resistance junction to ambient, 6.0 mm 2 coppeer pads to each terminal. reverse voltage: 50 - 1000 v i fsm 1.0 1.7 - 55 --- + 175 a current: 1.0 a solderable ends d2 d2=d1 0 0.20 0.5 0.1 0.5 0.1 4.9 0.2 2.6 0.15 d1 do - 213ab 70 100 ma 50 75 30 10 45 4002 units suf suf suf suf suf suf suf 50 100 10 notes:1. measured with i f =0.5a, i r =1a, i rr =0.25a. a i r - 55 --- + 175 i (av) 1.0 dimensions in millimeters s uf4001-suf4007 surface mount rectifiers features m echani cal d ata http://www.luguang.cn mail:lge@luguang.cn
0.01 0.1 1.0 10 00.40.8 1.2 1.6 2.0 2.4 t j =25 pulse width=300 s SUF4001-suf4004 0.02 0.04 0.2 0.4 2.0 4.0 suf4005-suf4007 -1.0a -0.25a 0 +0.5a 1cm t rr pulse generator (note2) d.u.t. 1 nonin- ductive 50 n 1. 10 n1. oscilloscope (note 1) (+) 50vdc (approx) (-) (-) (+) fig. 2 - maximum non-repetitive forward peak forward surge current, (a) number of cycles at 60hz surge current 12 4 6 8 10 20 40 60 80 100 50 40 30 20 10 0 8.3ms single half sine-wave (jeded method) fig. 1 - typical forward current average forward current, (a) ambient temperature, ( ) derating curve 1.0 .8 .6 .4 .2 0 0 25 50 75 100 125 150 175 single phase half wave 60hz resistive or inductive load fig. 3 - typical instantaneous forward characteristics instantaneous forward current, (a) instantaneous forward voltage, (v) t j = 100 t j = 25 fig. 4 - typical reverse characteristics instantaneous reverse current, (ua) percent of rated peak reverse voltage, (%) 0 20 40 60 80 100 120 140 .01 .04 .1 .4 10 fig.5 -- test circuit diagram and reverse recovery time characteristic notes:1.rise time = 7ns max.input impedance = 1m 2.rise time =10ns max.source impedance=50 set time base for 25 ns/cm 22pf. s uf4001-suf4007 surface mount rectifiers ratings and charactieristic curves http://www.luguang.cn mail:lge@luguang.cn
|