? north america tel: 800.366.2266 / fax: 978.366.2266 ? europe tel: 44.1908.574.200 / fax: 44.1908.574.300 ? asia/pacific tel: 81.44.844.8296 / fax: 81.44.844.8298 visit www.macomtech.com for additi onal data sheets and prod uct information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 1 spdt switch with integral cmos driver 800 - 2000 mhz rev. v5 SW-335 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. features ? low cost plastic soic-8 package ? integral ttl / cmos compatible driver ? matched input and output ? low distortion: > 40 dbm ip 3 @ 900 mhz and > 62 dbm ip 2 @ 900 mhz ? low dc current: < 1.5 ma typical per supply description m/a-com?s SW-335 is a terminated gaas mmic spdt with an on-chip ttl / cmos driver in a low- cost, soic 8-lead plastic package. the SW-335 is ideally suited for use in applications where low power consumption and small size are required. typical applications inclu de switch matrices, filter banks, and general switching applications, in systems such as cellular, pcn / pcs, gps and 900 mhz ism band applications. the SW-335 is fabricated using a monolithic gaas mmic using a mature 1 micron process. the process features full passivation for increased performance and reliability. ordering information 1 absolute maximum ratings 7,8 7. exceeding any one or combination of these limits may cause permanent damage to this device. 8. m/a-com does not recommend sustained operation near these survivability limits. functional schematic pin configuration truth table 3,4,5,6 part number package SW-335-pin soic-8 lead package SW-335tr forward tape and reel SW-335smb sample test board ttl/cmos rfc-rf1 rfc-rf2 1 off on 0 on off control inputs 3. logic 0 = 0 to 1 v 4. logic 1 = 3.5 to 5 v, 10 a typical. 5. v dd = 5 + 0.5 v @ <1.5 ma typical. 6. v gg = -5 + 0.25 v @ < 1.5 ma parameter absolute maximum rf input power +31 dbm max. control voltages v dd v gg v ctl maximum v ctl minimum +6 vdc -6 vdc +6 vdc -1 vdc operating temperature -40c to +85c storage temperature -65c to +150c pin no. function description 1 gnd rf ground 2 rfc rf in/out 3 ttl transistor logic 4 gnd rf ground 5 rf1 rf in/out 6 v gg gate voltage 7 v dd drain voltage 8 rf2 rf in/out 1. reference application note m513 for reel size information. 2. all sample boards include 5 loose parts.
? north america tel: 800.366.2266 / fax: 978.366.2266 ? europe tel: 44.1908.574.200 / fax: 44.1908.574.300 ? asia/pacific tel: 81.44.844.8296 / fax: 81.44.844.8298 visit www.macomtech.com for additi onal data sheets and prod uct information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 2 spdt switch with integral cmos driver 800 - 2000 mhz rev. v5 SW-335 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. electrical specifications 9,10 : t a = +25c, v dd = 5.0 v, v gg = -5.0 v soic-8 ? parameter test conditions units min. typ. max. insertion loss 800-2000 mhz db ? 0.9 1.1 isolation 800-1000 mhz 1000-1500 mhz 1500-2000 mhz db db db 35 35 30 45 38 32 ? ? ? vswr 800-1000 mhz 1000-2000 mhz ratio ratio ? ? 1.2:1 1.2:1 1.3:1 1.3:1 1 db compression 900 mhz dbm ? 29 ? t rise , t fall t on , t off transients 10% to 90% rf, 90% to 10% rf 50% control to 90% rf, control to 10% rf in-band ns ns mv ? ? ? 75 200 20 ? ? ? input ip 2 2-tone, 10 dbm (13 dbm total) 900 mhz dbm 40 45 ? input ip 3 2-tone, 10 dbm (13 dbm total) 900 mhz dbm 62 70 ? current v dd @ 5.0 v v gg @ -5.0 v v ctl @ 0 v v ctl @ 5.0 v ma ma a a ? ? ? ? 1.1 -0.8 -5 10 1.5 -1.5 -10 20 9. all measurements are in a 50 ? system. 10. dc blocks required on rf ports. ? meets jedec moisture sensitivity level 1 requirements.
? north america tel: 800.366.2266 / fax: 978.366.2266 ? europe tel: 44.1908.574.200 / fax: 44.1908.574.300 ? asia/pacific tel: 81.44.844.8296 / fax: 81.44.844.8298 visit www.macomtech.com for additi onal data sheets and prod uct information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 3 spdt switch with integral cmos driver 800 - 2000 mhz rev. v5 SW-335 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. typical performance curves input vswr vs. frequency isolation insertion loss output vswr (?on? state) vs. frequency handling procedures please observe the following precautions to avoid damage: static sensitivity gallium arsenide integrated circuits are sensitive to electrostatic discharge (esd) and can be damaged by static electricity. proper esd control techniques should be used when handling these devices. 0.0 0.3 0.6 0.9 1.2 0.8 1.0 1.2 1.4 1.6 1.8 2.0 70c 25c 0c frequency (ghz) 1.00 1.05 1.10 1.15 1.20 1.25 0.8 1.0 1.2 1.4 1.6 1.8 2.0 70c 25c 0c frequency (ghz) 1.00 1.05 1.10 1.15 1.20 1.25 0.8 1.0 1.2 1.4 1.6 1.8 2.0 70c 25c 0c frequency (ghz) 30 35 40 45 50 0.8 1.0 1.2 1.4 1.6 1.8 2.0 +70c +25c 0c frequency (ghz)
|
