800-867-8426 ? info@opticomm.com ? www.opticomm.com ? contact opticomm for custom requirements. * chromatic dispersion and additional losses should be taken into account. optical wavelength fiber output receiver budget conn 1310 1550 1270-1610 type mode suffix type power sensitivity loss range* type (cwdm) ? led mm l1 50 /125 -8 dbm -24 dbm 16 db 3 km st 62.5/125 ? laser sm l2 09/125 -3 dbm -26 dbm 18 db 25 km fc ? laser sm l3 09/125 -3 dbm -26 dbm 23 db 70 km fc ? laser sm l4 09/125 -4 dbm -26 dbm 22 db 25-70 km fc digital video/audio/data multi-channel system the fdv series digital systems are analog to digital, digital to analog, 8-bit or 10-bit modulated, led or laser-based video multiplexers with optional combinations of simplex or duplex 24-bit audio and various data signals, all over one multimode or singlemode fiber. the multi-channel transmission is achieved by digital modulation schemes and time division multiplexing (tdm) techniques. for the video portion, only a single wavelength is used. this assures the best possible signal uniformity. the fdv series is ideal for the transmission of multiple video with audio and/or data, where only one fiber is available. video, audio and data come in banks of two. status indicators on video, carrier detect, voltage, optical levels, and temperature are monitored via leds. features ? multimode or singlemode operation over one fiber ? digital transmission ? true dc restoration ? flat frequency response ? complies with rs-170 & rs-170a eia & rs-250c short haul standards ? traffic & intelligent transport system ? compatible with ntsc, pal, and secam video signals for cctv ? no emi or rfi and no ground loops ? rack mount hot swappable ? various data protocols available from rs-232, rs-422, rs-485 or contact closure fdv series digital video/audio/data multi-channel systems system design all units come in small module or insert card versions. the cards can be inserted into our 18 slot, 19" multiverse ? rack mountable card cage (cc-18-80w), or one of our smaller desktop card racks (dtcr series). the fdv series is compatible with the mdm-7000 series for multi-channel single-fiber solutions. sample products * fdv-8400 fdv-8800 fdv-8422 fdv-8/4/88/0 fdv-8404 *numerous configurations available opticomm reserves the right to change specifications without notice
composite video, audio & data made in the usa video video in/out impedance 75 ? video in/out level 1 volt peak to peak, 1.5 volts max video bandwidth 5 hz to 7 mhz @ -3db differential gain/phase < 1.0 % typical / < 0.7 typical linearity/tilt 0.9 % typical / 0.5 % typical compatibility ntsc, pal, secam, rs-170, rs-170a signal to noise ratio >68 db using rs-250c short haul standards @ 1 km bit resolution 8-bit or 10-bit connector type bnc audio audio in/out impedance 600 ? or 10k ? - balanced or unbalanced audio in/out level -6 to +6 dbm frequency response 10 hz to 20 khz signal to noise ratio > 90 db weighted total harmonic distortion < 0.01%, 1 khz at maximum modulation bit resolution 24-bit code connector type hd 15 pin female data data rate dc to 1 mbps bit error rate 10 -9 data formats available async rs-232, rs-422, rc-485/2w, genlock, manchester, 20 ma current loop, biphase, ttl, or six contact closures connector type hd 15 pin female general dimensions & weight stand alone (sa): all others/dtcr-2: 7.16? l x 1.75? w x 6.5?h 53 oz insert card (ic): all others (2 slot): 6.3? l x 1.7? w x 4.0? h 29 oz temperature operating: -20 c to +70 c; storage; -30 c to +85 c humidity 0 to 95% non-condensing operating voltage 12 v dc (200 ma) or 24 v ac (300ma) or 110/220 v ac vibration/shock up to 5 g's/up to 12 g's diagnostics status monitoring led indication sample configuration fdv-8000 xmt fdv-8000 rcv fdv series rcv fdv series xmt optiva ? multi-signal transmission platform network management sdi and hd-sdi composite video, audio & data audio/fsk/intercom rgb/vga/dvi data (ethernet/serial/usb) catv/rf & l-band optical switching, routing & redundancy passive multiplexing solutions enclosures, racks & frames power supplies and accessories optiva ? configurable communication platform network management sdi & hd-sdi composite video, audio & data rgb/vga/dvi audio/fsk/intercom data (ethernet/serial/usb) catv/rf & l-band optical switching, routing & redundancy passive multiplexing solutions enclosures, racks & frames power supplies & accessories
|
