Part Number Hot Search : 
L79LXXC 0603H A5800607 MLL979B HMM5139B KTC2347 PM73121 MP8725
Product Description
Full Text Search
 

To Download VLED15-230-900 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
  a division of cui inc date page series: description: 03/2011 1 of 5 led driver vled15 20050 sw 112 th ave. tualatin, oregon 97062 phone 503 . 612 . 2300 fax 503 . 612 . 2382 www.v-in nity.com model outut voltage 1 output current ouput power input voltage min. (v dc) max. (v dc) max. (ma) max. (w) nominal load (v ac) vled15-120-350 24 48 350 16.8 115 vled15-120-480 10 13.5 480 6.5 115 vled15-120-600 8 12 600 7.2 115 vled15-120-700 16 24 700 16.8 115 vled15-120-800 8 12 800 9.6 115 vled15-120-900 10 16 900 14.4 115 vled15-120-900l 8 12 900 10.8 115 vled15-120-1000 10 16 1,000 16 115 vled15-120-1200 10 14.1 1,200 16.92 115 vled15-120-1250 8 12 1,250 15 115 vled15-120-1400 2 8 11.5 1,400 16.1 115 vled15-120-1500 5 10 1,500 15 115 vled15-230-350 24 48 350 16.8 230 vled15-230-480 10 13.5 480 6.5 230 vled15-230-600 8 12 600 7.2 230 vled15-230-700 16 24 700 16.8 230 vled15-230-800 8 12 800 9.6 230 VLED15-230-900 10 16 900 14.4 230 VLED15-230-900l 8 12 900 10.8 230 vled15-230-1000 10 16 1,000 16 230 vled15-230-1200 10 14.1 1,200 16.92 230 vled15-230-1250 8 12 1,250 15 230 vled15-230-1400 2 8 11.5 1,400 16.1 230 vled15-230-1500 5 10 1,500 15 230 rohs features ?constant current ?high efficiency ?120 and 230 v ac inputs available ?0.35 ~ 1.5 a output current ?operates with industry standard dimmers ?compact encapsulated assembly ?active power factor correction ?over voltage, over current, over temperature, short circuit protection: auto recovery ?high temperature operation (up to 90c case) ?ul approved, enec approved, ce mark ?long life > 50,000 hours notes: 1. total led forward voltage must be within these ratings under all conditions including dimming 2. 80c maximum case rating
a division of cui inc date page series: description: 03/2011 2 of 5 led driver vled15 20050 sw 112 th ave. tualatin, oregon 97062 phone 503 . 612 . 2300 fax 503 . 612 . 2382 www.v-in nity.com input parameter conditions/description min nom max units current 115 v ac 0.22 a frequency range 47 63 hz power factor 120 v ac 90 % harmonics meets en61000-3-2, 3 inrush current 25c 5a output parameter conditions/description min nom max units voltage accuracy of set point 5 % load regulation 5 % over voltage protection auto restart over current protection auto restart short circuit protection auto restart control output dims without any flicker dimming range (conduction angle/output) use with incandescent dimmer 30 147 degrees safety & compliance parameter conditions/description min nom max units safety approvals ul60950-1, lps, ul8750, en61347-2-13 emc/emi en55015 class b, fcc class 47 cfr part 15 class b, en61000-4-(2,3,4,5,6,11), iec 61000-3-(2,3) ansi c62.41-1991 category a1, 2.5 kv ringwave rohs compliant yes leakage current 120 v ac 0.25 ma environmental parameter conditions/description min nom max units operating temperature case temperature without derating -30 90 c operating humidity non-condensing 5 95 % storage temperature -40 85 c surface temperature exposed surfaces, under all operating conditions 90 c over temperature protection auto restart reliability parameter conditions/description min nom max units mtbf at 90c case temperature, electrolytic life 50,000 hours
a division of cui inc date page series: description: 03/2011 3 of 5 led driver vled15 20050 sw 112 th ave. tualatin, oregon 97062 phone 503 . 612 . 2300 fax 503 . 612 . 2382 www.v-in nity.com isolation specifications parameter conditions/description min nom max units isolation meets the ul60950-1 reinforced, double insulation nec (class 2) en60598-1 class ii dimming requirements dimming of the driver shall be possible with standard triac based incandescent dimmers that chops the ac voltage as shown below or with electronic low voltage dimmers that employ reverse phase control. during the rapid rise time of the ac voltage when the dimmer turns on, the driver shall not generate any voltage or current osc illations and inrush current shall be controlled. during the on time of the ac input, the driver shall regulate the output. the rms value of the driver output current shall be proportional to the on time of the ac input voltage. care must be taken to assure that the minimum load requi rements are met. multiple drivers/leds may be connected to the dimmer in order to meet the minimum load requirement. chopped ac input to driver ac wall power dimming range when operating with an incandescent dimmer, the rms output current shall vary depending upon the conduction angle and rms value of the applied ac input voltage. the following graph shows the typical output versus conduction angle at various line voltages. the specified dimming range shall be from 30 degrees through 147 degrees conduction angle. operation throughout this dimming r ange shall be monotonic and produce a smooth transition of light output in both directions of the dimming range. at 120 v ac or 240 v ac input, the driver shall achieve full rated output current at less than 147 degree conduction angle. typical io vs conducon angle 0 0.2 0.4 0.6 0.8 1 1.2 0 20406080100120140160 vac conducon angle (degrees) output current (a) normalized to i set 100v (200v) 115v (230v) 132v (264v)
a division of cui inc date page series: description: 03/2011 4 of 5 led driver vled15 20050 sw 112 th ave. tualatin, oregon 97062 phone 503 . 612 . 2300 fax 503 . 612 . 2382 www.v-in nity.com dimming requirements the vled15 series of drivers operate from either 90vac to 135 v ac or 176 v ac to 265 v ac, at 47 to 63 hz. the drivers will op erate at voltages down to 20 v ac for the 120 v versions and 40 v for the 240 v ac versions. the following graph shows the typical outpu t current versus ac input voltage without a dimmer attached and with a typical led as the load. nominal output current shall be achieved at <115 v ac and <230 v ac when the output voltage is at the nominal of the particular range. when the output voltage is at the maximum valu e, nominal current must be achieved at <120 v ac and <240 v ac. typical vac(v) vs io(a) 0 0.2 0.4 0.6 0.8 1 1.2 020406080100120140 % of nominal input voltage output current (a) normalized to i set
20050 sw 112th ave. tualatin, or 97062 phone: 503-612-2300 800-275-4899 fax: 503-612-2383 website: www.cui.com specified ac/l (black) ac/n (white) vout + (red) b input output tolerance: 0.3mm unless otherwise vout - (black) 1:1 led driver copyright 2011 by cui inc. title: mm [inches] vled15 vled15 pc file name: approved by: drawn by: units: part no. scale: zrj rev: rev. description date a new drawing 7/29/2010 b model update and added dimensions 3/21/2011 scale: 1:2 b b 81.62 3.213 2.213 56.22 93.40 0.374 3.677 5.00 (2 plcs) (2 plcs) 152.00 5.984 9.50 103.40 4.071


▲Up To Search▲   

 
Price & Availability of VLED15-230-900

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X