 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| 8 Pin 5 Tap High Speed CMOS (HCT) Compatible Active Delay Lines Delays are 5% or 2 nS Tap Total 12* 12* 12* 12* 12* 12* 12* 15 17 18 19 20 21 22 24 30 22 24 26 28 30 32 36 45 27 30 33 36 39 42 48 60 32 36 40 44 48 52 60 75 DIP Part Number EPA1130-32 EPA1130-36 EPA1130-40 EPA1130-44 EPA1130-48 EPA1130-52 EPA1130-60 EPA1130-75 SMD Part Number EPA1130G-32 EPA1130G-36 EPA1130G-40 EPA1130G-44 EPA1130G-48 EPA1130G-52 EPA1130G-60 EPA1130G-75 Delays are 5% or 2 nS Tap Total 20 25 30 35 40 50 60 70 100 40 50 60 70 80 100 120 140 200 60 75 90 105 120 150 180 210 300 80 100 120 140 160 200 240 280 400 100 125 150 175 200 250 300 350 500 DIP Part Number EPA1130-100 EPA1130-125 EPA1130-150 EPA1130-175 EPA1130-200 EPA1130-250 EPA1130-300 EPA1130-350 EPA1130-500 SMD Part Number EPA1130G-100 EPA1130G-125 EPA1130G-150 EPA1130G-175 EPA1130G-200 EPA1130G-250 EPA1130G-300 EPA1130G-350 EPA1130-500 Whichever is greater. * Inherent Delay Delay times referenced from input to leading edges at 25C, 5.0V. DC Electrical Characteristics Test Conditions Parameter VIH VIL VOH VOL IL I CC TRO NH High Level Input Voltage VCC = 4.5 to 5.5 Low Level Input Voltage VCC = 4.5 to 5.5 High Level Output Voltage VCC = 4.5V,IO=-4.0mA @V IH or VIL Low Level Output Voltage VCC = 4.5V,IO= 4.0mA @V IH or VIL Input Leakage Current VCC = 5.5V @V or VIL IH Supply Current VCC = 5.5V, V =0 IN Output Rise Time (.75 - 2.4 Volts) High Fanout VCC = 5.5V, V = 4.0V OH Schematic Min Max Unit 2.0 0.8 4.0 0.3 Volt Volt Volt Volt 8 VCC 7 2 6 3 5 OUTPUT 10 1.0 uA 15 mA 4 nS LSTTL Load INPUT 1 4 GROUND Input Pulse Test Conditions @ 25C EIN PW TRI PRR VCC Pulse Input Voltage Pulse Width % of Total Delay Input Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ PW 500nS Pulse Repetition Rate @ PW > 500nS Supply Voltage 3.2 150 2.0 1.0 100 5.0 Unit Volts % nS MHz KHz Volts Recommended Operating Conditions VCC VI VO IO PW* D* TA DC Supply Voltage DC Input Voltage Range DC Output Voltage Range DC Output Source/Sink Current Pulse Width % of Total Delay Duty Cycle Operating Free Air Temperature Min 4.5 0 0 40 0 Max 5.5 VCC VCC 25 40 70 Unit Volt Volt Volt mA % % C *These two values are inter-dependent. SMD Package .03 PCA EPA1130G-32 D.C. .100 .500 Max. .250 Max. .02 DSA1130/G Rev. B 3/27/01 DIP Package White Dot Pin#1 .410 .100 .500 Max. .100 .250 Max. .020 Typ. .050 .300 .020 Typ. .120 Min, .365 Max. QAF-CSO1a Rev. B 8/25/94 PCA EPA1130-32 D.C. .280 Max. .400 Max. .280 Max. .055 Pad Layout .01 Typ. .010 Typ. Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = 1/32 .XX = .030 .XXX = .010 ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791 29 |
Price & Availability of EPA1130-100
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |