 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 3.3V SURFACE MOUNT CLOCK OSCILLATOR ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage (Vcc) UNITS MINIMUM -40 -0.5 NOMINAL MAXIMUM 85 7.0 UNITS C Vdc TABLE 2.0 MINIMUM NOMINAL 341.20000 400.00000 622.08000 644.51000 644.53125 666.51430 669.32660 3.3 -60 -90 -130 -135 MAXIMUM UNITS NOTE TABLE 1.0 NOTE CW 0701 FPLD52TE1 622.08M FPLD52TE1 DESCRIPTION OPERATING SPECIFICATIONS PARAMETER Center Frequency Total Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Jitter (BW=10Hz to 20MHz) Jitter (BW=12kHz to 80MHz) SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset (Fo) -50 0 50 70 3.465 100 5 1 - MHz ppm C Vdc mA ps rms ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz 1 (Vcc) (Icc) 3.135 - The Connor-Winfield FPLD52TE1 is a 3.3V Clock Oscillator (XO) with Differential LVPECL outputs and Enable/Disable function. The FPLD52TE1 is designed for use with applications requiring low jitter and tight stability. No multiplication schemes are used in this oscillator design. INPUT CHARACTERISTICS PARAMETER Enable Input Voltage (Low) Disable Input Voltage (High) (Vil) (Vih) MINIMUM 2.275 NOMINAL MAXIMUM 1.68 UNITS Vdc Vdc TABLE 3.0 NOTE 2 2 FEATURES LOW PROFILE, SURFACE MOUNT PACKAGE 3.3V OPERATION - LOW VOLTAGE PECL OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle at 50% Level Rise / Fall Time 20% to 80% (Voh) (Vol) MINIMUM 2.275 45 NOMINAL 50 MAXIMUM 50 1.68 55 1 UNITS Ohms Vdc Vdc % nS TABLE 4.0 NOTE 3 LOW JITTER <1pS RMS FREQUENCY TOLERANCE: 50ppm TEMPERATURE RANGE 0 to 70C DIFFERENTIAL LVPECL OUTPUTS ENABLE / DISABLE FUNCTION TAPE AND REEL PACKAGING PACKAGE CHARACTERISTICS Package TABLE 5.0 Non-hermetic package consisting of an FR4 subs trate with grounded metal cover. PROCESS RECOMMENDATIONS Solder Reflow Wash Notes 1.0 2.0 3.0 TABLE 6.0 The component solder used internal to this device has a m elting point of 221C. The peak temperature inside the device should be less t han or equal to 220C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. ORDERING INFORMATION FPLD52TE1 - 622.08MHz Inclusive of calibration @ 25C, frequency stabilit y vs. temperature, supply and load variations, shock, vibrat ion and aging for ten years. Control voltage (Vc) = 1.65 Vdc. When oscillator is disabled the true output is in a low state (Vol) and the complementary output is in the high stat e (VoH). Outputs are enabled with no connection on enable pad. 50 ohm termination into Vcc -2V or Thevein equivalent. LVPECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Ec181 PAGE 1 OF 2 REV: 01 DATE: 8/4/03 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS .140 MAX (3.56mm) CW FPLD52TE1 622.08M Pin 1 2 3 4 5 6 Function N/C Enable / Disable Ground (Case) Output Q Comp Output Q Vcc Dimensional Tolerance: .005 (.127mm) 2 N/C E/D Specifications subject to change without notice. DATA SHEET #: Ec181 PAGE 2 OF 2 REV: 01 DATE: 8/4/03 aCopyright 2001 Connor-Winfield all rights reserved. |
Price & Availability of FPLD52TE1
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |