 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| VCS1026 622.080MHz VCSO FEATURES * Industry Standard 5x7mm SMT Footprint * +3.3 Vdc Supply Voltage * -40C to 85C Temp. Range * LVPECL differential outputs * 50ppm Absolute Pull Range (APR) * Output Enable/Disable Function * SAW resonator * Extremely Low Jitter * Tape & Reel Packaging * RoHS Compliant DESCRIPTION Surface mount 5x7mm VCSO operating at 3.3V supply with complementary LVPECL outputs for use in datacom & telecom applications. ELECTRICAL SPECIFICATIONS Parameter Operating Conditions Nominal Frequency Operating Temperature Range Storage Temperature Range Supply Voltage Supply Current Load VCC; 5% Icc; Max. VCC; TA = 25C load = 50 to VCC - 2V output to VCC - 2V fNOM Conditions & Remarks Min -40 -55 3.135 +20 50 0.3 50 - Typical 622.080 3.300 60 50 100 180 50 2 Max 85 125 3.465 70 -150 3.0 10 Unit MHz C C Vdc mA ppm k Vdc ppm/V ppm kHz % Frequency Stability Frequency vs. Temperature ref to TA = 25C; VC = constant Electronic Frequency Control Input Impedance Control Voltage Range Gain Transfer Absolute Pull Range Modulation Bandwidth Linearity NOTE 1: APR; all causes (see note 1) -3dB ref. 100Hz Deviation from best linear fit Zi VC ; positive monotonic transfer Minimum guaranteed frequency shift (f/fNOM) under all conditions (temperature, aging, supply voltage, load) for 15 years at an average effective operating temperature of +55C Document No. VCS1026 06/28/2007 Page 1 - 4 Rev. A CTS Electronic Components, Inc. 171 Covington Drive Bloomingdale, IL 60108 www.ctscorp.com VCS1026 622.080MHz VCSO ELECTRICAL SPECIFICATIONS (Continued) Parameter Output Parameters Output Signal Amplitude Rise/Fall Times Duty Cycle Start up time 20% to 80% @ 50% of output signal to reach 90% of final amplitude 100Hz 1kHz Phase Noise 10kHz 100kHz 1MHz 12kHz to 20MHz (calculated from Phase Noise) 50kHz to 80MHz (calculated from Phase Noise) VOL VOH Conditions & Remarks Min Typical LVPECL 250 50 -85 -110 -140 -143 -143 0.16 0.16 Max Unit VCC-1.025 VCC-1.620 45 - 400 55 10 -75 -100 -130 -140 -140 0.3 0.3 Vdc ps % ms dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz ps RMS ps RMS Phase Jitter LVPECL OUTPUT WAVEFORM TEST CIRCUIT, LVPECL LOAD Pad 2 Low "0" Open High "1" OUTPUT ENABLE/DISABLE LOGIC Pad 4 outputs disabled HI Z outputs enabled Output outputs enabled Output Pad 5 HI Z Comp. Output Comp. Output Document No. VCS1026 06/28/2007 Page 2 - 4 Rev. A CTS Electronic Components, Inc. 171 Covington Drive Bloomingdale, IL 60108 www.ctscorp.com VCS1026 622.080MHz VCSO MECHANICAL SPECIFICATIONS PACKAGE DRAWING PIN 6 PIN 5 PIN 4 PIN #1 MARK VCS1026 CTS YYWW PIN 1 PIN 2 PIN 3 EXPOSED GROUND PLANE AND COVER CASTELLATION 2 PLACES 0.56 TYP [.022] PIN 1 PIN 2 PIN 3 2.68 [.105] MAX 1.27 [.050] TYP 1.47 [.058] 1.68 [.066] 5.180.10 [.204.004] 1.27 TYP [.050] 1.90 [.075] 1.68 [.066] 1.47 [.058] PIN 6 PIN 5 PIN 4 2.54 [.100] 5.08 [.200] 7.520.10 [.296.004] BARRIER COVERING OVER RESIST MASK OVER GROUND PLANE Lead Termination Finish: Gold flash, <10 micro inch, over 100 micro inch minimum Ni plated Cu Co-Planarity (from seating plane): 0.1 [0.004] maximum Dimensions in mm and [inches] 1) Control Voltage - VC 2) Enable/Disable Control 3) Ground/Case 4) Output 5) Complementary Output 6) Supply Voltage - VCC Document No. VCS1026 06/28/2007 Page 3 - 4 Rev. A CTS Electronic Components, Inc. 171 Covington Drive Bloomingdale, IL 60108 www.ctscorp.com VCS1026 622.080MHz VCSO SUGGESTED SOLDER PAD GEOMETRY 5.08 [.200] 2.54 [.100] 1.70 [.067] 3.83 [.151] 2.34 [.092] 5.54 [.218] 1.68 [.066] Dimensions are in mm and [inches]. MAXIMUM SOLDERING PROFILE Temperature 217C 260C (Absolute max temperature) Time 60-150 sec 10 sec. max Note: Part is not designed to be reflowed in an inverted position. TAPE AND REEL INFORMATION 17.5 O13 2.0 O1.50 8.00 4.00 1.75 3.10 2.90 120 7.50 7.80 7.60 16.00 O60 O180 5.60 5.40 DIRECTION OF FEED DIMENSIONS ARE IN MM O23 Device quantity is 1000 pieces max. per 180mm reel. MSL Level: 1 This product is fully compliant to RoHS Directive 2002/95/EC Document No. VCS1026 06/28/2007 Page 4 - 4 Rev. A CTS Electronic Components, Inc. 171 Covington Drive Bloomingdale, IL 60108 www.ctscorp.com |
Price & Availability of VCS1026
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |