![]() |
|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
PM4354 COMET-QUAD Four Channel Combined E1/T1/J1 Transceiver/Framer FEATURES * Monolithic device that integrates four T1/E1 framers and line interfaces for shorthaul and longhaul applications. * Software selectable between T1/J1 and E1 operation on a per device basis. * Provides digitally programmable longhaul and shorthaul pulse templates and line build out. * Meets or exceeds T1/J1 and E1 shorthaul and longhaul network access specifications including ANSI T1.102, T1.403, T1.408, AT&T TR 62411, ITUT G.703, G.704 as well as ETSI 300011, CTR-4, CTR-12 and CTR-13. * Provides encoding and decoding of B8ZS, HDB3 and AMI line codes. * Provides receive equalization, clock recovery and line performance monitoring. * Provides transmit and receive jitter attenuation. * Provides four full-featured HDLC controllers, each with 128-byte transmit and receive FIFO buffers. * Provides a two-frame payload slip buffer to allow independent backplane and line timing. * Automatically generates and transmits DS-1 performance report messages to ANSI T1.231 and ANSI T1.408 specifications. * Provides PRBS generators and detectors on each tributary for error testing at DS1, E1 and N x 64 Kbit/s rates as recommended in ITU-T O.151 and O.152. * Provides an 8-bit microprocessor bus interface for configuration, control, and status monitoring. * Uses line rate system clock. * Provides an IEEE P1149.1 (JTAG) compliant test access port (TAP) and controller for boundary scan test. * Implemented in a low power 2.5/3.3 V CMOS technology. * Available in a high density 208-pin fine pitch PBGA (17 mm by 17 mm) package. * Provides a -40 C to +85 C industrial temperature operating range. RECEIVER * Typical signal recovery of up to -43 dB at 1024 kHz (E1) and up to -44 dB at 772 kHz (T1/J1). * Guaranteed minimum signal recovery of -32 dB at 1024 kHz (E1) and -36 dB at 772 kHz (T1/J1) using PIC-22 gauge cable emulation. * Frames to DSX/DS-1 signals in SF, and ESF formats. * Frames to ITU-T G.704 basic and CRC-4 multiframe formatted E1 signals. The framing procedures are consistent with ITU-T G.706 specifications. * Frames to TTC JT-G704 multiframe formatted J1 signals. Supports the alternate CRC-6 calculation for Japanese applications. Frames in the presence of and detects the Japanese yellow alarm. * Tolerates more than 0.4 UI peak-topeak, high frequency jitter as required by AT&T TR 62411 and Bellcore TRTSY-000170. * Provides programmable in-band loopback activate and deactivate code detection. BLOCK DIAGRAM BTCLK[1:4] XIBC Inband Loopback Code Generator XPDE Pulse Density Enforcer T1-XBAS/E1-TRAN Basic Transmitter, Frame Generation, Alarm Insertion, Signaling Insertion, Trunk Conditioning Tx-ELST Transmit Elastic Store TPSC Per-DS0 Controller BTIF Backplane Transmit System Interface BTSIG[1:4] BTFP[1:4] BTPCM[1]/CASBTD BTPCM[2:4] CCSBTD MVBTD TxTIP1[1:4] TxTIP2[1:4] TxRING1[1:4] TxRING2[1:4] XLPG Transmit LIU TJAT Digital Jitter Attenuator TxCM[1:4] A[10:0] XCLK CTCLK RSYNC CSD Clock Synthesis and Distribution TOPS Timing Options TDO TDI TCK TMS TRSTB RDB TDPR HDLC Transmitter XBOC Bit Oriented Code Dector PRBS Pattern Generator/ Detector MPIF Microprocessor Interface WRB CSB ALE INTB RSTB RDLC HDLC Receiver D[7:0] PIO CMV8MCLK CMVFPC CMVFPB JTAG Test Access Port PMON Performance Monitor Counters T1-APRM Auto Performance Response Monitor ALMI Alarm Integrator RBOC Bit Oriented Code Dector RxTIP[1:4] RxRING[1:4] RLPS Receive LIU CDRC Clock and Data Recovery RJAT Digital Jitter Attenuator IBCD T1/E1-FRMR Inband Frame AlignLoopback Code ment, Alarm Detector Extraction PDVD Pulse Density Violation Detector BRCLK[1:4] SIGX Signalling Extractor RPSC Per-DS0 Controller BRIF Backplane Receive System Interface BRSIG[1:4] BRFP[1:4] BRPCM[1]/CASBRD BRPCM[2:4] CCSBRD/ MVBRD RVREF[1:4] One of Four T1/J1 or E1 Transceiver/Framers FRAM Framer RAM Rx-ELST Receive Elastic Store PMC-2000091 (r3) PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS' INTERNAL USE (c) Copyright PMC-Sierra, Inc. 2001 PM4354 COMET-QUAD Four Channel Combined E1/T1/J1 Transceiver/Framer * Provides diagnostic, line and per-DS0 payload loopbacks. * Extracts up to three HDLC links to an H-MVIP Bus to support the D-channel, for ISDN Primary Rate Interfaces, and the C-channels, for V5.1/V5.2 interfaces. Detects the V5.2 link identification signal. attenuation, jitter transfer and residual jitter specifications of AT&T TR 62411 and ETSI CTR 12 and CTR 13. Provides a FIFO buffer for jitter attenuation and rate conversion in the transmit path. Supports unframed mode and framing bit, CRC, or data link by-pass. Allows insertion of framed or unframed in-band loopback code sequences. Allows insertion of a data link in ESF mode. Optionally inserts a datalink in the E1 national use bits. Inserts, from an H-MVIP bus, up to three HDLC links to support the Dchannel, for ISDN Primary Rate Interfaces, and the C-channels, for V5.1/V5.2 interfaces. Transmits TTC JT-G704 multiframe formatted J1 signals. Supports the alternate ESF CRC-6 calculation for Japanese applications. * Supports transmission of the alarm indication signal (AIS) and the yellow alarm signal. Supports Japanese yellow alarm generation. * Provides ESF bit-oriented code generation. * * * * APPLICATIONS * Wireless Base Transceiver Station and Digital Loop Carrier (DLCs). * Enterprise Router. * DSLAM. * APON Optical Network Unit (ONU). * Integrated Access Device (IAD). * Voice Gateway. * Channel and Data Service Units (CSU/DSU). * Digital Private Branch Exchanges (PBX). * Test Equipment. TRANSMITTER * Generates DSX-1 shorthaul and DS-1 longhaul pulses with programmable pulse shape compatible with AT&T, ANSI and ITU requirements. * Generates E1 pulses compliant to G.703 recommendations. * Provides line outputs that are current limited and may be tristated for protection or in redundant applications. * Provides a digital phase locked loop for generation of a low jitter transmit clock complying with all jitter * * TYPICAL APPLICATIONS 3G WIRELESS BASESTATION CONTROLLER Modem Card PM7350 S/UNI-DUPLEX Fabric Backplane MODEMS WAN Interface Line Card (Protect) WAN Interface Line Card (Working) Modem Card RF Card PM7350 S/UNI-DUPLEX PM7328 S/UNI-ATLAS1K800 AAL2 MUX PM7351 S/UNIVORTEX PM7351 S/UNIVORTEX MODEMS PM7815 PALADIN-15 RF E1/T1/J1x4 PM4354 COMET-QUAD PM7341 S/UNI-IMA-8 E1/T1/J1x4 PM4354 COMET-QUAD PM7329 S/UNI-APEX1K800 Modem Card PM7350 S/UNI-DUPLEX MODEMS INTEGRATED ACCESS DEVICE UTOPIA L2/ Any-PHY UTOPIA L2 PM73124 AAL1gator-4 E1/T1/J1 x 4 to PBX, Video, CODEC PM4354 COMET-QUAD Voice Processing with AAL2 PM7329 S/UNI-APEX1K800 PM7340 S/UNI-IMA-8 PM4354 COMET-QUAD x2 E1/T1/J1 x8 to ATM WAN LAN MAC PM7366 FREEDM-8 FR/ATM & AAL5 SAR PM7328 S/UNI-ATLAS1K800 Head Office: PMC-Sierra, Inc. 8555 Baxter Place Burnaby, B.C. V5A 4V7 Canada Tel: 604.415.6000 Fax: 604.415.6200 To order documentation, send email to: document@pmc-sierra.com or contact the head office, Attn: Document Coordinator All product documentation is available on our web site at: http://www.pmc-sierra.com For corporate information, send email to: info@pmc-sierra.com PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS' INTERNAL USE PMC-2000091 (r3) (c) Copyright PMC-Sierra, Inc. 2001. All rights reserved. August 2001. S/UNI is a registered trademark and AAL1gator-4, Any-PHY, FREEDM-8, SPECTRA-155, FREEDM-32, COMET-QUAD, and PMC-Sierra are trademarks of PMC-Sierra, Inc. |
Price & Availability of PM4354
![]() |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |