| PART |
Description |
Maker |
| LTC3723-1 |
Synchronous Push-Pull PWM Controllers
|
linear
|
| NCP1561DR2 NCP1561 |
Dual Output PWM Controller
Push-Pull PWM Controller for 48 V Telecom Systems
|
ONSEMI[ON Semiconductor]
|
| 54CAA-B24-D18/P50L 54CAA-B24-S20/P50L 54CAA-B24-B2 |
Panel Control w/Push-Pull Switch
|
Bourns Electronic Solut...
|
| TDA4718 TDA4700 Q67000-Y639 TDA4718A Q67000-Y594 |
From old datasheet system
Control IC for Single-Ended and Push-Pull Switched-Mode Power Supplies SMPS
Control IC for Single-Ended and Push-Pull Switched-Mode Power Supplies (SMPS)
|
SIEMENS[Siemens Semiconductor Group]
Infineon
|
| MCP6542 MCP6542-I/MS MCP6542-I/P MCP6542-I/SN MCP6 |
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current ...
Push-Pull Output Sub-Microamp Comparators
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the 16 lead PDIP, SOIC and 14 lead TSSOP pack
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package,
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package.
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC, MSOP and five le
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current ...
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
From old datasheet system
IC,VOLT COMPARATOR,DUAL,CMOS,TSSOP,8PIN,PLASTIC
|
Microchip Technology Inc.
|
| POD3-R-DFS111 HRMJ-POD3P POD3-J-DFS111 POD3-PR-1 P |
BOARD TERMINATED, FEMALE, RF CONNECTOR, RECEPTACLE
Push-Pull Complete Locking Coaxial Connectors (PC Card Type 2 Mountable) 推挽式总锁定同轴连接器（PC卡类挂墙
Push-Pull Complete Locking Coaxial Connectors (PC Card Type 2 Mountable)
|
HIROSE[Hirose Electric]
Hirose Electric USA, INC.
HIROSE ELECTRIC Co., Ltd.
|
| XC91061 |
PWM Control,PWM/PFM Switching Control, Step-Up DC/DC Converters, Externally Applied Vref
|
Torex Semiconductor
|
| ADM1815-10AKS-REEL ADM1815-10AKS-RL7 ADM1815-10ART |
Microprocessor Supervisory in SOT-23 with Active Low Push-Pull Output Choices
Microprocessor Supervisory in SOT-23 with Active High and Low Push-Pull Output, Positive Reset Output
Microprocessor Supervisory in SOT-23 with Low Active OpenDrain Output Choices
Microprocessor Supervisory in SOT-23 with Active Low Open Drain Output Choices
Microprocessor Supervisory in SOT-23 with Active High Push-Pull Output
Microprocessor Supervisory in SOT-23 with Open Drain Output Choices
1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3
|
ANALOG DEVICES INC
|
| RP13A-12PC-13PC RP13A-12PC-13SC RP13A-12JC-13PC RP |
Push-Pull Lock Connector
|
http://
Hirose Electric
|
| SGM8704 |
Push-Pull Output Comparator
|
Shengbang Microelectron...
|
| DS1810 DS1810-10 DS1810-15 DS1810-5 DS1810R-10TR D |
5V EconoReset with Push-Pull Output
|
MAXIM - Dallas Semiconductor
Dallas Semiconducotr
DALLAS[Dallas Semiconductor]
|
| MC-7856 MC-7856G |
CATV 22 dB PUSH-PULL AMPLIFIER
|
NEC Corp.
NEC[NEC]
CEL[California Eastern Labs]
|
