| PART |
Description |
Maker |
| AT91M40800NBSP |
Attention: additional NWAIT constraints for the AT91M40800
|
Atmel Corp
|
| AWT6130 |
The AWT6130 provides the additional output power margin RF designers need to overcome additional post-PA insertion loss in tri-mode ...
Cellular Dual Mode AMPS/CDMA 3.5V 29dBm Power Amplifier Module
|
Anadigics Inc
ANADIGICS, Inc
|
| VCE1 |
Additional Standard Crystal Oscillators
|
Vectron
|
| TFMS5380 |
Additional Opto Device
From old datasheet system
|
Vishay
|
| CF-1000-10 |
Quick change of cross section without the need for additional adjustments
|
PHOENIX CONTACT
|
| F16011 |
~35° medium beam. Clean appearance with no additional attachment interface
|
Ledil, Inc.
|
| 95622-4884 SD-95622-007 0956224884 |
Modular Jack, Right Angle, Fully Shielded, SMT, 8/8, Additional Panel Grounding
|
Molex Electronics Ltd.
http://
|
| 2706030 |
Lower part of housing, fully assembled, with additional serial contact, open, no. of positions 10 2
|
PHOENIX CONTACT
|
| ADM489 ADM488 |
Low Power, Slew Rate Limited RS-485, Contains an Additional Receiver and Driver Enable Control
|
Analog Devices
|
| SP3051 |
The SP3051 integrates low capacitance rail-to-rail diodes with an additional zener diode to protect each I/O pin against ESD and high surge events.
|
Littelfuse
|
| REL-IR-4L-230AC |
Plug-in industrial relay with power contacts and additional hard gold plating, 4 PDTs, test button, status LED, mechanical switch setting display, coil voltage: 230 V AC
|
PHOENIX CONTACT
|
