| PART |
Description |
Maker |
| MPX2100 MPX2100A MPX2100DP MPX2100GVP MPX2100AS MP |
0 to 100 kPa (0 to 14.5 psi) 40 mV FULL SCALE SPAN (TYPICAL) 000千帕4.5 PSI）的全尺寸为40 mV跨度（典型）
(MPX2100 / MPX2101) 0 to 100 kPa (0 to 14.5 psi) 40 mV FULL SCALE SPAN (TYPICAL)
Sensor
|
Motorola Mobility Holdings, Inc.
Motorola, Inc.
MOTOROLA[Motorola Inc]
MOTOROLA[Motorola, Inc]
|
| MCP6542 MCP6542-I/MS MCP6542-I/P MCP6542-I/SN MCP6 |
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current ...
Push-Pull Output Sub-Microamp Comparators
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the 16 lead PDIP, SOIC and 14 lead TSSOP pack
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package,
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package.
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC, MSOP and five le
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current ...
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
From old datasheet system
IC,VOLT COMPARATOR,DUAL,CMOS,TSSOP,8PIN,PLASTIC
|
Microchip Technology Inc.
|
| MCP603T-E/ST MCP603T-I/ST MCP6022-I/SN MCP6022-I/S |
MCP603 operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 and an offset ...
The MCP602 dual operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 ...
MCP601 operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 and an offset ...
The MCP604 quad operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230. ...
|
Microchip
|
| C1300 C130009 |
Typical Applications
|
Vectron International, Inc
|
| AQN121L AQN121V AQN321L AQN321VL AQN221L AQN221V A |
TYPICAL APPLICATIONS
|
Panasonic Semiconductor
|
| HG2-AC240V-F HG3-AC240V-F HG4-AC240V-F HG4-AC100V- |
TYPICAL APPLICATIONS
|
Panasonic Semiconductor
|
| F-LAN |
Typical F-LAN Application
|
THOR communications
|
| SPS-135C SPS-1118C SPS-235C SPS-281C SPS-181C SPS- |
Phototransistor Typical Characteristics
|
Sanyo
List of Unclassifed Manufacturers
Electronic Theatre Controls, Inc.
|
| PCA1550B-LF |
PHASE NOISE (1 Hz BW, typical)
|
Z-Communications, Inc
|
| HTQF5361 |
1.0 pS phase jitter ( typical )
|
Mercury United Electron...
|
| TC105303ECT TC105333ECT TC105503ECT TC105 TC105303 |
The TC105 is a step-down (Buck) switching controller that furnishes output currents of up to 1A (max) while delivering a typical ...
The TC105 is a step-down (Buck) switching controller that furnishes output currents of up to 1A (max) whiledelivering a typical efficiency of 92%. The TC105 normally operates in pulse width modulation mode (PWM), but automatically switches
PFM/PWM Step-Down DC/DC Controller
|
MICROCHIP[Microchip Technology]
|
