Part Number Hot Search : 
AN4110 B5150 SST4393 2501N 09081 00200 AP4407GS FZ44N
Product Description
Full Text Search
  leave Datasheet PDF File

For leave Found Datasheets File :: 10336    Search Time::3.766ms    
Page :: | 1 | 2 | 3 | 4 | 5 | 6 | <7> | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 |   

    XR16L2450 XR16L2450IJ XR16L2450IM

Exar Corporation
Part No. XR16L2450 XR16L2450IJ XR16L2450IM
OCR Text ...ansmit Data. If it is not used, leave it unconnected. UART channel A Receive Data. Normal receive data input must idle at logic 1 condition. If it is not used, tie it to VCC or pull it high via a 100k ohm resistor. UART channel A Request-to...
Description 2.25V TO 5.5V DUART

File Size 279.64K  /  30 Page

View it Online

Download Datasheet





    XR16L255007 XR16L2550IM XR16L2550 XR16L2550IJ XR16L2550IL

EXAR[Exar Corporation]
Part No. XR16L255007 XR16L2550IM XR16L2550 XR16L2550IJ XR16L2550IL
OCR Text ...t channel A. If it is not used, leave it unconnected. UART channel A Receiver Ready (active low). This output provides the RX FIFO/RHR status for receive channel A. If it is not used, leave it unconnected. RXRDYA# - 34 31 O ...
Description LOW VOLTAGE DUART WITH 16-BYTE FIFO

File Size 342.85K  /  46 Page

View it Online

Download Datasheet

    XR16L2550 XR16L2550IJ XR16L2550IL XR16L2550IM

Exar Corporation
Part No. XR16L2550 XR16L2550IJ XR16L2550IL XR16L2550IM
OCR Text ...t channel A. If it is not used, leave it unconnected. UART channel A Receiver Ready (active low). This output provides the RX FIFO/RHR status for receive channel A. If it is not used, leave it unconnected. RXRDYA# - 34 31 O ...
Description LOW VOLTAGE DUART WITH 16-BYTE FIFO

File Size 248.85K  /  45 Page

View it Online

Download Datasheet

    XR16L255107 XR16L2551IM XR16L2551 XR16L2551IL

EXAR[Exar Corporation]
Part No. XR16L255107 XR16L2551IM XR16L2551 XR16L2551IL
OCR Text ... will stay at logic zero level. leave this output unconnected. REV. 1.1.3 TXRDYA# - 43 O UART channel A Transmitter Ready (active low). The output provides the TX FIFO/THR status for transmit channel A. If it is not used, le...
Description LOW VOLTAGE DUART WITH POWERSAVE

File Size 354.52K  /  49 Page

View it Online

Download Datasheet

    EXAR[Exar Corporation]
Part No. XR16L2750CJ XR16L2750_05 XR16L2750 XR16L2750CM XR16L2750IJ XR16L2750IM
OCR Text ...See Table 2. If it is not used, leave it unconnected. UART channel A Receiver Ready (active low). This output provides the RX FIFO/RHR status for receive channel A. See Table 2. If it is not used, leave it unconnected. UART channel B Transm...
Description 2.25V TO 5.5V DUART WITH 64-BYTE FIFO

File Size 452.23K  /  48 Page

View it Online

Download Datasheet

    MN6650 MN6650A

Panasonic Semiconductor
Part No. MN6650 MN6650A
OCR Text ...t input. of 1.0 Vpp.) Test pin. leave open. Test pin. leave open. Test pin. leave open. Test pin. leave open. "L" level: pull-in state. "L" level: pull-in state. "L" level: reset. "L" level: ON. (tristate) (tristate) (tristate) (tristate) (...
Description Signal Processing LSI for CD Players

File Size 31.07K  /  5 Page

View it Online

Download Datasheet

    ALLEGRO[Allegro MicroSystems]
Part No. A8435EESTR-T A8435
OCR Text ... 2-bit parallel or PWM dimming, leave open or tie to VIN (see table 1). For single-wire serial input dimming, connect to GND (see figure 2). When CTRL is open or HIGH: Enable and dimming control input 1 (see table 1). When CTRL is grounded:...
Description High Efficiency Charge Pump White LED Driver

File Size 360.54K  /  9 Page

View it Online

Download Datasheet

    Rohm Co., Ltd.
Part No. BD90FC0WEFJ BD50FC0WEFJ
OCR Text ...o connection (connect to gnd or leave open) 5 en enable pin 6 n.c. no connection (connect to gnd or leave open) 7 n.c. no connection (connect to gnd or leave open) 8 v cc input pin reverse gnd substrate(connect to gnd) n.c...
Description 35V Voltage Resistance 1A LDO Regulator

File Size 531.39K  /  20 Page

View it Online

Download Datasheet

    ANALOG DEVICES INC
AD[Analog Devices]
Part No. ADCMP565BP ADCMP565 ADCMP565BPZ
OCR Text ...onic NC QA Function No Connect. leave pin unconnected. One of two complementary outputs for Channel A. QA will be at logic high if the analog voltage at the noninverting input is greater than the analog voltage at the inverting input (provi...
Description DUAL COMPARATOR, 6000 uV OFFSET-MAX, 0.375 ns RESPONSE TIME, PQCC20
Dual Ultrafast Voltage Comparator (Formerly the AD53519)

File Size 192.74K  /  16 Page

View it Online

Download Datasheet

For leave Found Datasheets File :: 10336    Search Time::3.766ms    
Page :: | 1 | 2 | 3 | 4 | 5 | 6 | <7> | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 |   

▲Up To Search▲

 




Price and Availability




 
Price & Availability of leave

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X
0.4880678653717